Map Ideas
Moderators: Jay2k1, DavidM, The_One
A basketball map, have the goal be a standard BR goal, but horizontal. then have some sort of mesh to make it easier, angled backboard or a quartersphere that rests on top of the goal, on the back half. There'd be a jump pad for slam dunks. also need a blocking volume to keep from shooting underneath.
this is a map i thought of in the same post as when i thought of TheBook.
..."a dining room table with serviettes/napkins as the walls, two candles at either end and an open/empty box of matches as the goals. And maybe 20-metre wine glasses in the middle for good measure. Ball spawn could be on a coaster."
Now what I was thinking was; scrap the walls altogther...so just have the rectangular table with white tablecloth, ball spawn on coaster, one candle at either end in middle, keep the empty box of matches as the goals, have a wine glass and a bottle of wine somewhere, lines could be marked by sketches on napkins (as you do in a restaurant).....DB-Vintage '63
..."a dining room table with serviettes/napkins as the walls, two candles at either end and an open/empty box of matches as the goals. And maybe 20-metre wine glasses in the middle for good measure. Ball spawn could be on a coaster."
Now what I was thinking was; scrap the walls altogther...so just have the rectangular table with white tablecloth, ball spawn on coaster, one candle at either end in middle, keep the empty box of matches as the goals, have a wine glass and a bottle of wine somewhere, lines could be marked by sketches on napkins (as you do in a restaurant).....DB-Vintage '63
Umm, ok I don't know if this is possible, but here goes....
Take a chunk of the JK2 map where you go through a TIE Fighter Hangar, with the wide doors at either end and the lift in the middle (anyone?) and the blue magnetic seal thingo on the left...(if going through map normally) since JK2 was made with the Q3 engine...is it possible to rip chunks of maps like this and import them to UEd? (BTW this is an idea for a DB Map..)
Take a chunk of the JK2 map where you go through a TIE Fighter Hangar, with the wide doors at either end and the lift in the middle (anyone?) and the blue magnetic seal thingo on the left...(if going through map normally) since JK2 was made with the Q3 engine...is it possible to rip chunks of maps like this and import them to UEd? (BTW this is an idea for a DB Map..)
-
dreamstation
- Junior Member
- Posts: 2
- Joined: 29-03-2003 13:52
- Contact:
)